Now we are ready to wire the light source to a power plug. This step involves electrical wiring, which is safe as long as you never work on an electrical device while it is plugged in. Please make sure that you avoid plugging your LCD or the light source until you are finally ready to use your projector and it is fully assembled.

Light Kit Wiring
To wire your SV-11 250w light source, first drill a 1/2 inch hole in the back MDF panel of the projector. Then insert the non-plug end of the power supply cable through the hole into the projector. Tie a knot in the cable on the inside of the projector, leaving about 6-8 inches of extra wire inside the projector, and ensuring that the power cable cannot be pulled back through the hole. Finally, follow the 250w version of the lamp and ballast wiring instructions.

© 2002-2005 DIY For Life Inc